Speedtest Settings
26 EX10
Test
Thresholds
Allows enabling and setting the threshold values that will be used to
declare the pass/fail verdict for each test. Thresholds are disabled by
default.
Latency Threshold when enabled, allows entering the maximum
threshold value in ms.
Download Threshold when enabled, allows entering the minimum
and maximum threshold values in Mbits/s.
Upload Threshold when enabled, allows entering the minimum and
maximum threshold values in Mbits/s.
Interface
Allows selecting the test interface and its parameters.
Type/Rate indicates the EX10 device test port used for the Speedtest:
Base-T Electrical.
Connector indicates the port connector type which is RJ45.
Auto-Negotiation indicates the state of auto-negotiation which is
enabled.
Speed is set to auto detection (Auto).
Network
MAC Address is the unique Media Access Control Address given to the
EX10 device Ethernet port
DHCP when selected (default and dimmed) dynamically obtains an IP
address from a Dynamic Host Configuration Protocol (DHCP) server.
The source IP Address, Subnet Mask, Gateway, DNS1, and DNS2
parameters are displayed.
To Next Page
Loading...
