Test Setup - Test Configurator, Timer, and System
152 MAX-800 Series
Services - Global
Frame Size indicates the frame size of each service. Tap on the Frame
Size button to modify the frame size of each service.
Framing indicates the framing of each service. Tap on the Framing
button to modify the Frame Format, Network Layer, Transport Layer,
VLAN, and MPLS when applicable (see Modify Frame Structure from
the MAC/IP/UDP on page 121).
VLAN (ID/Priority) indicates the ID and Priority of each VLAN level for
each service. Tap on the VLAN button to modify the VLAN settings (see
VLAN from the MAC/IP/UDP on page 121).
Addressing indicates the source and destination IP addresses for each
services. Tap on the Addressing button to modify the addressing (see
MAC and IP from the MAC/IP/UDP on page 121).
Batch button allows bulk configuration for services addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From Apply To, select all services the copy
applies to and tap on the Copy From to proceed.
SLA Button
The SLA parameters are displayed and configurable per service. Click on
the desired column button to access the configuration settings.
See General Button on page 151 for more information on check boxes,
Direction, and Service Name.
See SLA Parameters on page 159 for more information on CIR, CIR+EIR,
CBS, EBS, Max Jitter, Max Latency, and Frame Loss Rate.
To Next Page
Loading...
