Test Results
276 MAX-800 Series
Service Performance
Service Performance
From the Test menu, tap Results, and the Service Performance tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
SLA Parameters
The configured CIR, Max Jitter, Frame Loss Rate and Max Latency/Max
Round-Trip Latency SLA parameters are displayed. Refer to Services -
Profile on page 154 for more information. For Dual Test Set or Dual Port
topology, parameters are displayed respectively for both local (L) and
remote (R) directions, or for both port directions.
Metrics
Current, Average, Minimum, Maximum, and Estimate (Jitter) measured
values for each metric are reported. Direction, available with Dual Test
Set or Dual Port topology indicates respectively results for local (L) and
remote (R) directions, both port directions, and Round-Trip for Latency
when in Round-Trip Latency Measurement Mode (see Global Options on
page 102). For Dual Test Set, results for remote to local are obtained at the
end of each step.
RX Rate indicates the measured utilization throughput.
Jitter (ms) indicates the measured delay variation.
Latency (ms) indicates the measured round-trip latency (delay).
Note: For the Current value, 0 is displayed when no RX rate has been measured
in the last second.
To Next Page
Loading...
