Test Results
292 MAX-800 Series
Summary (EtherSAM)
Committed
Frame Loss Rate indicates the rate of frames that are lost. The
reported value is the maximum rate of Frame Loss from all burst
sequences and ramp steps excluding the CIR+EIR, EBS, and
Traffic Policing steps. Frame Loss is displayed as a percentage
value when the remote unit does not support exponential notation.
Max. Jitter (ms) indicates the maximum measured delay
variation.
Max Latency (ms) indicates the maximum measured round-trip
latency (delay). For Dual Test Set the local to remote and remote to
local values are reported for One-Way Latency Measurement Mode
while a single round-trip value is reported for Round-Trip Latency
Measurement Mode (see Global Options on page 102).
Avg RX Rate, for Service Performance Test, indicates the
measured average utilization throughput.
Excess
Max RX Rate, for Service Configuration Test, indicates the
measured maximum utilization throughput.
VLAN Preservation indicates if any VLAN mismatch occurred during
any step of a Ramp or Burst tests as follows:
Grey: Undefined
Green: No Mismatch detected
Red: Mismatch detected
To Next Page
Loading...
