After the machine has been removed from the packaging
place it on a level surface.
Remove the white protective cov
ering from the all parts of the
Remove the reservoir from the top of the machine and rinse it out.
the reservoir with water and place
back into the machine. Make sure
both rubber tubes are placed back into the reservoir.
will not have the second tube)
NOTE: Do not use water that has had all of the minerals removed.
Minerals are necessary for the sensors in the boiler to work
properly. Notice that the water inlet line has a water softener on
Make sure that it fills with water and is not floating.
Plug the machine into a wall socket that matches the three
plug on the machine. It is important that the machine is grounded. If
please call Whole Latte Love
and ask to talk to a representative
in our technical department.
Turn on the main power switch and move the
position. The pump will go on and fill both the steam boiler and
oiler. Leave the lever in the UP
steady stream of water coming out of the brew group.
position and let them machine heat up.
empty portafilter in the brew group so t
hat it will be hot when you’re
the water in the reservoir gets
18 minutes for both the brew
boiler and steam boiler to reach
operating temperatures. Please see the brewing tips section for information on how to