Expobar BREWTUS IV - Initial Start-Up Instructions (Brewtus IV-R); 8. Water Softener Instructions

14
Initial Start
-
Up
Instructions Brewtu
s IV
-
R
After the machine has been removed from the packaging
,
place it on a level surface.
1.
Remove the white protective covering from the all parts of the machine.
2.
Attach
the water line f
rom the machine to your water line connection and turn on
the water supp
ly to the machine. Run the
line from the bottom of the machine to
your drain line.
3.
Plug the machine into a wall socket that matches the three
-
pronged plug on the
machine. It is importa
nt that the machine is grounded. If you have any questions
regarding this please give
Whole Latte Love a call at 888
-
411
-
5282 and ask to
talk to
a representative
in our technical department.
4.
Turn on the main power switch and move the
brew group lever
to t
he
UP
position.
The pump will go on and fill both the steam boiler and the brew b
oiler. Leave the
lever in the UP
position until there is a steady stream of water coming out of the
brew group. If the pump runs for more than 1 minute and water
does not come
out
of the brew group
,
please turn off the machine
and call Whole Latte Love
T
echnical
S
upport.
5.
Move the lever to the
DOWN
position and let them machine heat up.
6.
Always leave the empty portafilter in the brew group so that it will be hot
when
you’re ready
to brew
.
Note: It will take around 18 minutes for both the bre
w
boiler and steam boiler to
reach operating temperatures. Please see the brewing tips section for information on
how to get the
best
results
out of your new Brewtus IV.
8
.
Water Softener
Instructions
(Brewtus
IV
Machines
with Reservoir O
nly
)
The Brewtus
IV
comes with a water softener that will help keep damaging minerals out
of the boilers.
There is nothing that has to be done
at
initial start up
stage
to get the water
softener ready for
use.
See the chart below for recommendation
how to
recharge the water softener. Use the
following r
echarging instructions:
Water softener filter
Water reservoir
a)
Fill a container with water (same amount as the reservoir)
b)
Add
3 tablespoons of salt
to the water container
.
c)
Stir the salt into the water.