Expobar BREWTUS IV - Manual Cleaning of Brew Components; 14. Cleaning the Housing; 15. Troubleshooting Common Issues; Machine Power and Water Supply Issues

20
Cleaning the Brewing Components by Hand:
Cleaning the brewing surfaces is done as follows:
Note:
The cleaning of the brew head should be done while the machine is co
ld to avoid
burns.
1.
R
emove the shower screen. The shower screen is located at the same place the
portafilter installs
into the machine. Using a flat
-
head screwdriver, wiggle the screen
out. The screen and gasket will come out together.
2.
Separate the screen
from the gasket as the solution can damage plastic and rubber
parts.
Note: Remember which
side of the gasket faces up.
3.
Mix a solution of Urnex Cafiza and very hot water in a container. Use two
tablespoons of the cleaner and fill the container halfway, as
the solution will foam.
4.
Soak the shower screen, shot baskets and portafilter head in the solution for about 10
minutes. Take care not to soak the portafilter handle; as the solution may damage the
plastic.
5.
After a thorough cleaning,
rinse all parts with f
resh clean water.
6.
Reassemble in reverse order.
14
.
Cleaning the Housing
Use a non
-
abrasive cleaner and a soft cloth.
Do not forget to disconnect the machine from
the electrical supply before cleaning.
1
5
.
Trouble Shooting Guide
The
M
achine
D
oes
N
ot
T
urn
O
n:
Make sure the power is
on and the machine is plugged in.
Make sure that there is power to the outlet in the wall.
Make sure there is water in the reservoir
Coffee
C
omes
O
ut
T
o
o Q
uickly:
See the Golden
Rule.
The coffee probably has to be ground fi
ner and or purchase fresher
coffee.
Coffee
C
omes
Out T
o
o
S
lowly.
See the Golden R
ule, coffee may be ground to
o
fine.
Clean the brew group as described in the cleaning instructions.
(
Make sure the reservoir
is full of water Brewtus III V only).