The lever on the front of the machine controls a valve inside of the brew group and it
also controls the pump for brewing. The lever has three positions
: When in the up position
turns on for brewing and the valve
inside the brew group opens and allows water to flow over the coffee.
lever in the middle position when
the machine is not in use or
off but the pressure in the brew
group has not been released
so do not remove the portafilter.
: When the lever is lowered, the
off and any water pressure
left on the coffee is released
and deposited into the drip tray through the tube
the bottom of the brew group.
the lever to the down position
before removing the portafilter from the brew group
The main power switch is located on the top left side of
the front of the machine.
will automatically start heating up and the water level
that the steam boiler is full of water. Note: When the main
power switch is turned on
. Only the brew boiler will
heat up. This will allow for a quicker
up for when you only want to brew.
light goes on whenever the heating elem
ent in the steam boiler is on.
perfectly normal for this light to go on and off with or without any discernable pattern
when the machine is in use.
This pressure gauge shows the pressure i
nside the steam boiler. The pressure come
. This is the proper boiler pressure and there
should be no need to make any adjustments. The needle on the pressure gauge will go
the steam boiler heating element is
When this knob is turned counter clockwise
the steam valve is opened
To Next Page
Loading...
