CARAT
18
PROGRAMMING
This section explains how to program the doses dispensed automatically by the drink buttons.
Keep the continuous button pressed over 8 seconds, all the lights in the keypad will light up and
continuous button will flash.
Within 30 seconds press any selection that you want to reprogram (1 short espresso, 1 long espresso,
2 short espresso, 2 long espresso). Notice that all the lights will turn off except the selection you made
and the continuous button.
The group begins to dispense espresso, when the desired volume of espresso is reached, press the
selection button that is light up to stop dispensing, this volume will now be stored as default.
Repeat this process with all the selections that needs to be reprogrammed.
In case you only want to reprogram one of the selections, acts as previously described and only reprogram
one selection. The other selections will keep the existing settings.
Programming the coffee dosage
Keep the continuous button pressed over 8 seconds, all the lights in the keypad will light up
and continuous button will flash.
Press the continuous button for less than 1 second. Water will dispense from the hot water
wand.
Press the same button again to stop the dispensing and store the new volume. Different water
volumes can be stored in each keypad.
Programming of hot water volume
Keep the continuous button pressed over 8 seconds, all the lights in the keypad will light up
and continuous button will flash.
Immerse the steam wand in the liquid to be heated up.
Press the steam button .
When the liquid reaches the desired temperature, press steam button again to stop. The new
temperature is now stored.
When programming this button it will only affect the temperature of the liquid, not the time steaming.
Once the electronic steam wand with temperature probe reaches the programmed temperature it will
automatically turn off. Different volumes of liquid will not affect the temperature.
Programming temperature for the turbo steamer
Note:
Programming any of the options on the left-hand drink buttons (when viewing the machine
from the front) automatically sets the dispensing volumes on all of the other drink buttons. This
only applies to the left-hand drink buttons. Programming other drink buttons only modifies the
option selected.
i
Important:
Use a porta-filter filled with fresh coffee for every new dose you program.
To Next Page
Loading...
