Expobar CARAT 2GR - TROUBLESHOOTING

CARAT
32
Boiler temperature
Multi boiler setting
Groups temperature
In this section the temperature of the boiler is set.
To increase temperature, press the button (one short espresso),
to decrease it, press the button
(one long espresso).
To accept the setting and proceed to the next menu, press the continuous
button .
Here is set the actual number of extra boilers that the machine has.This
setting is factory set, and must not be modified, as this would cause a
malfunctioning.
To modify the setting press the button (one short espresso),
or
(one long espresso). The options are:
- GR1+GR2 (One main boiler and 2 groups boilers)
- OFF (Only one main boiler machine)
To accept the setting and proceed to the next menu, press the continuous
button .
Here it is adjusted the temperature for each group and the main boiler. If the
previous menu was set to “OFF”, only the temperature for the main boiler
will appear in this menus.
To increase temperature value, press the button (one short
espresso), to decrease it, press the button
(one long espresso).
 Grouptemperature1–Grouptemperature2–Mainboilertemperature
Once adjusted each temperature, press the continuous button as
to adjust the next group/boiler temperature.
Once set the temperature of the last group/boiler, when pressing the
continuous button
it will procceed to the next menu.
Boiler temperature
XXºC YYYºF
Heating Group
XXXX
Group temperature
XXºC YYYºF
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
Fig. A
Fig. B
Fig. C
PROGRAMMING