Expobar CARAT 2GR - MESSAGES AND ALARMS; Display messages, alarms, and warnings overview

CARAT
31
PROGRAMMING
Chronometer
Maintenance cycle
Temperatures: ºC or F
The displays (See fig.A) of each group have different working modes:
Brewing chronometer: When brewing an espresso, the display acts as a
chronometer measuring the time taken to erogate the espresso.
Pulses: When brewing an espresso, the displays acts as a volume counter
showing the volume brewed in cubic centimeters.
Disabled: Easch group display is not affected when brewing espresso.
To change between the different option use press the button (one
short espresso) or
(one long espresso).
To accept the setting and proceed to the next menu, press the continuous
button
.
Here it is adjusted the Number of espresso brewings needed for maintenance
cycle, (shower screen replacing, gaskets, etc.) When the service counter
reaches the number set here, on the display it is shown the warning “Service
needed”, and the Phone of the service.
To increase this value, press the button (one short espresso),
to decrease it, press the button
(one long espresso).
To accept the setting and proceed to the next menu, press the continuous
button
.
To show the temperature in ºF (Fahrenheit) press the button (one
short espresso),
To show the temperature in ºC (Celsius) press the button (one
long espresso).
To accept the setting and proceed to the next menu, press the continuous
button
.
Crono
option
Maintenance cycle
XXXX
Temperature
ºC/ºF
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
Fig. A
Fig. B
Fig. C