Expobar diamant - Machine Status Indicators; Programming via Drink Buttons

DIAMANT
25
PROGRAMMING
Machine status
Programming using the drink buttons
Turning the Boiler ON or OFF-
With the machine in ON status, press the Continuous
and 1 Long Espresso buttons
simultaneously to turn the boiler ON or OFF (multi-boiler machines only).
Standby Mode-
On the left keypad, press and hold the Continuous button
then press the 2 Short Espressos
button
, this will put the machine in STANDBY mode.
Automatic Cleaning-
With the machine in ON status, press the Continuous
and 1 Short Espresso
buttons simultaneously to activate the automatic cleaning function.
Activating the Programming Menus-
There are two programming menus that can be adjusted while the machine is in ON status. The
first programming menu is reached by pressing the Continuous button
for 8 seconds,
until the “Doses Program” is shown on the display. From this program it is possible to access the
second menu by pressing Continuous button
again for 8 seconds. Learn more about these
programming menus and their functions in the following pages.
C
A
B
D
The machine has 3 different statuses:
ON
The machine is active and ready for use. Generally when switching on the main
switch, the machine will enter this status quickly. (See “ON” fig.A)
STANDBY
The main switch is turned on, but the machine’s display reads OFF (See
“STANDBY” fig.B). This is a power saving mode. To get to this status, begin
with the machine in ON status. Press and hold the Continuous button ,
then press the 2 Short Espressos button . The display will read
“OFF” and go to STANDBY status. To exit STANDBY status press the
button 2 Short Espressos button again, the machine will return to
ON status.
OFF
The machine is totally powered down or electricity is disconnected.
Publicity
EXPOBAR
Max
hh:mm
day
o
C
Min
OFF
hh:mm
day
“ON” fig.A
“STANDBY” fig.B