DIAMANT
27
PROGRAMMING
Press the Continuous button for 8 seconds, all the lights in the keypad will light up and
Continuous button will flash, the display will read “Doses Programming Select 30s”.
Immerse the steam wand in the milk to be steamed or frothed.
Press the Steam button . The programmed temperature will appear on the digital display.
When the liquid reaches the desired temperature, press the Steam button again to stop
steaming. The new temperature is now stored.
Programming the turbo steamer temperature
Note:
The electronic temperature probe is designed to automatically stop the steam when the
programmed temperature is reached. Steaming times with the Turbo Steamer will vary depending
on the volume and temperature of the liquid being steamed or frothed, but final temperature will be
the same.
i
Use the following steps to program the espresso brew dosages for each Brewing Group and Drink Button
(each button can be programmed for a different dosing time if desired):
1. Place a Porta-filter filled with fresh espresso grounds in the Brewing Group.
2. Press the Continuous button
for 8 seconds, all the lights in the keypad will light up and
Continuous button will flash, the display will read “Doses Programming Select 30s”.
3. Within 30 seconds press the Drink Button to be reprogrammed. All of the button lights will turn
off except for the Continuous button and the one being programmed. Water will begin to flow and
espresso will begin dispensing.
4. Allow the beverage to dispense until the desired drink volume is reached, then press the Drink Button
that is being programmed to stop the water flow. This dosage time will now be stored as the default for
that Drink Button.
5. Repeat Steps 1-4 for all Drink Buttons to be reprogrammed.
Programming the espresso brewing dosages
Note:
Programming any of the options on the left-side bank of Drink Buttons (when viewing the
machine from the front) automatically programs the dosages on all of the other corresponding
Drink Buttons for the other Brewing Group(s). Always program the left-side buttons first, then
program the other Drink Buttons to the right afterward to store their specific dosages.
Note:
For safety and water conservation, all brewing settings have a maximum dispensing time of 5
minutes.
i
Important:
Use a porta-lter lled with fresh espresso grounds for every new brewing dosage
that is programmed.
i
To Next Page
Loading...
