Expobar diamant - Setting Auto On;Off Times

DIAMANT
28
PROGRAMMING
Auto On/Off
“Auto On/Off” Program controls when the machine will automatically turn
on and off via preset times when the main power switch remains on. This is a
power saving feature.
“Closed on Day” Program is a power saving feature that allows users to
specify one day per week that the machine will not be used, and therefore
should not turn on, heat the boiler, and go into On status. This feature is
optional and should only be used if needed.
Setting the “Auto On/Off” Program:
1. From within the “Clock Adjust” Program (see page 24) press the 2 Short
Espresso button
to enter the “Auto ON/OFF” Program (See fig. A).
The “ON” function will begin to flash.
2. Adjust the “ON” status by pressing the 1 Short Espresso or 1 Long
Espresso
buttons to move the hour value up and down that the
machine is expected to automatically start on. When the desired hour is
input (See fig.B), press the 2 Short Espressos button
to accept and
move to the minute input. Then adjust the minute value using the 1 Short
Espresso
or 1 Long Espresso buttons.
3. When the hour and minute that the machine will automatically turn ON has
been correctly input, press the Continuous button to accept the
program and move to the “Auto Off” Program. Programming the “OFF”
time is done in the same manner as the “Auto On” time by repeating steps
1 through 3 from above.
Setting the “Closed on Day” Program:
1. After “Auto ON/OFF” times have been confirmed, a day off can be
programmed using the “Closed on Day” Program (See fig. C). This feature is
only available when Auto On/Off is programmed.
2. To program the “Closed on Day” press the Short Espresso
or
1 Long Espresso
buttons until the desired day of the week is
showing
on the display. Then press the 2 Short Espressos button
to accept it.
Auto On/Off
On: Hh:mm
Auto On/Off
Off: Hh:mm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
Closed on
Day
1 short espresso ↑ +
1 long espresso ↓ -
2 short espresso OK
Continuous to conrm
fig. A
fig.B
fig.C
i
Note:
By default, the first value of each program will be - - : - - to indicate
that the function is disabled. When a value is added the function will
be enabled. To leave any function disabled, simply press the 2 Short
Espressos button while the display reads - - : - - to move on
to the next function.
i
Note:
To exit from a program
at any time press the
Continuous button
to scroll back
to the home display
screen. The number of
button presses will vary
depending on the program
in use.