29
Elen
R
SERVICE PROgRAMMINg
Accessing service programming
Language selection
Accessing these settings menus is only possible via the left-side button panel (when
the machine is viewed from the front).
To access the settings menus:
Turn the machine OFF (Standby mode) by pressing and holding down the
Continuous Dispensing button
and the 2 Short Espressos button
simultaneously (see fig. 11).
Hold down the Continuous Dispensing button for 15 seconds (until the display
shows the "Language" option, see fig. 12).
OFF hh:mm
Fig. 11
When "Language" is displayed, select the desired language.
To change language:
Press the 1 Short Espresso button (+) to cycle forward through the languages
and the 1 Long Espresso button
(-) to cycle backward through them.
Languages available: Spanish, English, French, Italian, German and Portuguese.
To accept the language selected and access the next menu, press the Continuous
Dispensing button
.
Language
Language
Fig. 12
Reset parameters to factory default
Data reset
completed
Fig. 10
To reset the control panel settings to the factory default:
Switch off the machine at the power switch.
Press and hold down the '1 Short Espresso' , 2 Short Espressos and
Continuous Dispensing buttons
then turn on the machine. Hold down the
buttons until the message shown in fig. 10 is displayed.
Turn the machine off and then on again. The machine will now be in stand-by mode.
Standby / OFF
(simultaneously)
Programming (press for
14+ seconds) / Next menu
ON / OK
+ / Forward
- / Back
To Next Page
Loading...
