34
Elen
R
SERVICE PROgRAMMINg
Maintenance cycles
Temperature unit (ºC or ºF)
Water filter: softener regeneration
This menu sets the number of coffees dispensed per maintenance cycle (before
replacing shower plates, gaskets, etc.). When the dispensing counter reaches the
number set (see fig. 26), the "Service" message will be displayed.
To increase the number, press the 1 Short Espresso button (+). To decrease it,
press the 1 Long Espresso button
(-).
The Service: alert menu displays the number of coffees dispensed.
To accept the setting selected and move on to the next menu, press the Continuous
Dispensing button
.
Maintenance cycles
N000
Fig. 26
To display the temperature in ºF (Fahrenheit), press the 1 Short Espresso button
.
To display the temperature in ºC (Celsius/centigrade), press the 1 Long Espresso
button
.
To accept the setting selected and move on to the next menu, press the Continuous
Dispensing button
.
Temperature
ºC / ºF
Fig. 27
This menu sets the volume of water in litres at which the control panel generates the
water-softener regeneration alert.
To increase the number, press the 1 Short Espresso button (+). To decrease it,
press the 1 Long Espresso button
(-).
The Litre counter menu displays the volume of water used by the machine.
To accept the setting selected and move on to the next menu, press the Continuous
Dispensing button
.
Water lter
No. of litres
Fig. 29
Boiler temperature
XXX ºC
Fig. 28
Set boiler temperature
This menu sets the boiler temperature.
To increase the temperature, press the 1 Short Espresso button (+). To
decrease it, press the 1 Long Espresso button
(-).
To accept the setting selected and move on to the next menu, press the Continuous
Dispensing button
.
Water-softener
model
Quantity of water softened, by hardness
(expressed in French degrees)
Salt
20º 30º 40º 60º 80º KG
L 8
1200 1000 900 700 500 1
L 12
1900 1500 1350 1050 750 1.5
Approximate number of litres of water softened per regeneration.
To Next Page
Loading...
Need help?
General
