18
COMFORT PLUS INSTALLATION
Chapter 4 Chapter 4
COMFORT PLUS INSTALLATION
Adaptation
Frame
Fixed
base
with rails
The Comfort Plus model is supplied with an iron sliding
base that allows to install it in a pre-existing ue.
This sliding base allows the easy extraction of the insert
both for pellet feeding inside the feed-box and for any
maintenance or cleaning at the end of the season.
If there is no pre-existing ue, one can be built using the
insert-holder pedestal (optional kit); in fact, the latter
xes the insert to the oor.
Component description:
Fixed base
Rail
Flue exhaust pipe
Primary air intake pipe
Socket
Adaptation frame
ASSEMBLY
The insert can be positioned on an existing base or using
the support and feeding kit (optional).
ASSEMBLY ON EXISTING BASE
First of all, check the presence of a current socket on the
rear of the insert so that the socket is accessible once
installation is completed.
After having evaluated the correct position, the machine
body must be detached in order to x the sliding base:
use the supplied Allen wrench to turn the lockbolt
clockwise.
Slide the insert out.
Tilt it to release it from the rails.
Use chalk to mark the blocking points of the base; then
make 8 mm holes for the steel expansion inserts.
Make a hole measuring 60 mm in correspondence with
the air intake.
Flue exhaust pipe
Primary air
intake
pipe
Ducting
Pipe
gure 4.1
gure 4.2
gure 4.3
To Next Page
Loading...
