10. USE
The stove you have purchased uses pellets as fuel. This type of material is produced from natural
waste from woodworking. By means of a special process, which does not require the use of any
binders or additives, the shavings are compressed in industrial machines under high pressure and
become solid wooden pellets. IT IS STRICTLY FORBIDDEN to burn any other material besides
pellets in our stove.
Failure to respect these instructions will void all warranties and may jeopardise the safety of the
appliance.
The first two or three times the stove is lit, the following recommendations should be observed:
• No children should be present, as the vapours emitted can be harmful for health. Adults,
too, should not stay in the vicinity for very long.
• Do not touch the surfaces, as they could still be unstable.
• Air the room thoroughly several times.
• The hardening of the surfaces is completed after several heating processes.
• This stove must not be used as a waste incinerator.
11. IGNITION
1. Before proceeding, check to make sure that:
a) the tank is loaded with pellets
b) the combustion chamber is clean
c) the brazier is clean and free
d) the fire door and the ash drawer are sealed
e) the power cable is connected correctly
f) the two-way switch on the back of the stove is in position 1
2. Press button 1 for three seconds; display D1 will show the message “START” and display
D2 shows the number 8, with the numbers decreasing each second. During this stage, the
stove carries out an automatic check on the efficiency of each single electrical component.
When this cycle is completed, display D1 shows the message “IGNITION” and display D2
shows “15” (the number of minutes for which the stove attempts the ignition stage,
decreasing by 1 every minute that passes).
NOTE:
The first time the stove is used, even if the tank is loaded with pellets, it is possible
that the pellets are not distributed to the combustion chamber for the first 15 minutes
because the worm screw for loading the pellets is empty. If the stove has not developed a
flame after the fifteen minutes have elapsed, the display shows the message “IGNITION
FAIL”. In this case, press button 1 for three seconds until D1 shows the message “OFF”.
Then switch the master switch off and on again and repeat steps 1 and 2.
3. If steps 1 and 2 are carried out correctly, as soon as the flame develops the stove enters
“START UP” mode.
4. After the start-up phase, the stove goes into normal operation: display D1 shows the room
temperature and D2 shows the heat setting.
WARNING!
1. NEVER USE FLAMMABLE LIQUIDS FOR LIGHTING.
2. WHEN FILLING, DO NOT BRING THE SACK OF PELLETS INTO CONTACT WITH THE
HOT STOVE.
N.B.: In the event of continued ignition failures, contact an authorised technician.
To Next Page
Loading...
