14.1 Weekly programmer
The weekly programmer enables you to set three heating periods over the course of the day, to be
used for each day of the week. The timetables for switch-on/off must be consecutive within the
same day, on a 24-hour basis (from 0 to 24), and not straddling more than one day.
e.g.: Switch-on 07.00 / switch-off 18.00 OK
Switch-on 22.00 / switch-off 05.00 ERROR
Before programming this function, you have to set the current day and time using the “
current day
and time setting
” instructions to provide a reference for the programming function.
To access the weekly programmer setting, press and hold button 3, press button 5, then release
both buttons at the same time. Use button 5 to move until display D2 shows “0” flashing.
The table below contains all the parameters of the weekly programmer function.
Parameter Display D1
Display D2
Function
Adjustment
buttons
Indication
Button to
confirm
0 Enable/disable weekly programmer 2 or 3 ON/OFF 5
1 Time of 1
st
switch-on 2 or 3 OFF or from 00:00 to 23:50 5
2 Time of 1
st
switch-off 2 or 3 OFF or from 00:00 to 23:50 5
3 Consents 1
st
switch-on/off for the various days 2 or 3 ON/OFF 1, ON/OFF 2, … ON/OFF 7 5
4 Installer parameter 2 or 3 00 5
5 Time of 2
nd
switch-on 2 or 3 OFF or from 00:00 to 23:50 5
6 Time of 2
nd
switch-off 2 or 3 OFF or from 00:00 to 23:50 5
7 Consents 2
nd
switch-on/off for the various days 2 or 3 ON/OFF 1, ON/OFF 2, … ON/OFF 7 5
8 Time of 3
rd
switch-on 2 or 3 OFF or from 00:00 to 23:50 5
9 Time of 3
rd
switch-off 2 or 3 OFF or from 00:00 to 23:50 5
A Consents 3
rd
switch-on/off for the various days 2 or 3 ON/OFF 1, ON/OFF 2, … ON/OFF 7 1
For example, let’s suppose we want to use the weekly programmer function with the three heating
periods as follows:
1
st
period: from 8.00 to 12.00 every day of the week except Saturday and Sunday
2
nd
period: from 15.00 to 22.00 only Saturday and Sunday
3
rd
period: not used
We can now proceed to setting the weekly programmer.
Parameter 0 (D2 = 0 (flashing) , D1 = on )
Use button 2 or 3 to activate the weekly programmer, setting the value to ON.
Parameter 1 (D2 = 1 (flashing), D1 =Ex. “08.00”)
Press button 2 or 3 to set “8.00”, which corresponds to the switch-on time of the 1
st
period. Press
button 5 to confirm and go to the next parameter.
Press button 4 to go back to the previous one.
Parameter 2 (D2 = 2 (flashing), D1 =Ex. “12.00” )
Press button 2 or 3 to set “12.00”, which corresponds to the switch-off time of the 1
st
period.
Press button 5 to confirm and go to the next parameter.
Press button 4 to go back to the previous one.
To Next Page
Loading...
