Extreme Networks Summit Summit24 - Page 199

Configuring OSPF
Summit24e3 Switch Installation and User Guide 199
config ospf ase-summary delete <ipaddress>
<mask>
Deletes an aggregated OSPF external route.
config ospf delete virtual-link <routerid>
<areaid>
Removes a virtual link.
config ospf delete vlan [<name> | all] Disables OSPF on one or all VLANs (router
interfaces).
config ospf direct-filter [<access_profile> |
none]
Configures a route filter for direct routes. If
none is specified, all direct routes are exported
if ospf export direct is enabled.
config ospf lsa-batching-timer <timer_value> Configures the OSPF LSA batching timer
value. The range is between 0 (disabled) and
600 seconds, using multiples of 5 seconds.
The LSAs added to the LSDB during the
interval are batched together for refresh or
timeout. The default setting is 30 seconds.
config ospf metric-table <10M_cost>
<100M_cost> <1G_cost>
Configures the automatic interface costs for 10
Mbps, 100 Mbps, and 1 Gbps interfaces. The
default cost for 10 Mbps is 10, for 100 Mbps is
5, and for 4 Gbps is 1.
config ospf routerid [automatic | <routerid>] Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is automatic.
config ospf spf-hold-time {<seconds>} Configures the minimum number of seconds
between Shortest Path First (SPF)
recalculations. The default setting is 3 seconds.
config ospf vlan <name> area <areaid> Changes the area ID of an OSPF interface
(VLAN).
Table 59: OSPF Configuration Commands (continued)
Command Description