70 Summit24e3 Switch Installation and User Guide
Managing the Switch
SNTP Example
In this example, the switch queries a specific NTP server and a backup NTP server. The switch is
located in Cupertino, CA, and an update occurs every 20 minutes. The commands to configure the
switch are as follows:
config timezone -480 autodst
config sntp-client update interval 1200
enable sntp-client
config sntp-client primary server 10.0.1.1
config sntp-client secondary server 10.0.1.2
config sntp-client update-interval <seconds> Configures the interval between polling for
time information from SNTP servers. The
default setting is 64 seconds.
disable sntp-client Disables SNTP client functions.
enable sntp-client Enables Simple Network Time Protocol
(SNTP) client functions.
show sntp-client Displays configuration and statistics for the
SNTP client.
Table 19: SNTP Configuration Commands (continued)
Command Description
To Next Page
Loading...
