Extreme Networks Summit X460-48t User Manual

Confidential and proprietary information of Extreme Networks. © 2011 Extreme Networks, Inc.
All rights reserved. DRAFT. October 20, 2011
Building a SummitStack Configuration
Summit Family Switches Hardware Installation Guide
182
Management Port Cabling
Connect the master, backup, and all other master-capable switches to your management network using
the Ethernet management port on the rear panel of each switch. If you choose the default redundancy
setup, only slots 1 and 2 are allowed to become master. You may connect all switch management ports
in the stack if you choose to do so. There is an alternate IP address configuration that will allow you to
directly log into an individual switch in the stack through its management port.
Stacking Port LEDs
Each stacking port has an LED. The LED is steady green if the link is OK, blinking green if traffic is
present, and off if no signal is present.

Extreme Networks Summit X460-48t Specifications

General

Brand	Extreme Networks
Model	Summit X460-48t
Category	Switch
Language	English