Confidential and proprietary information of Extreme Networks. © 2011 Extreme Networks, Inc.
All rights reserved. DRAFT. October 20, 2011
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
184
Safety Information
Read the information in this chapter thoroughly before you attempt to install or remove a
Summit switch.
See Appendix A, “Safety Information” for additional safety information and Appendix B, “Technical
Specifications” for additional information regarding regulatory compliance certifications.
Be sure that proper ESD controls are in use before switch maintenance is performed. This includes but is
not limited to wrist straps that are grounded to the switch chassis and earth grounds.
Be sure to connect the chassis ground wire before you connect any DC power cables.
Be sure to disconnect the ground wire after you disconnect all DC power cables.
Installing a Summit Family Switch (Models Other than
Summit X460, X480, and X650 Series)
This section describes how to install the following Summit family switches:
● Summit X150 series
● Summit X250e series
● Summit X350 series
● Summit X450 series
● Summit X450a series
● Summit X450e series
For instructions to install the Summit X460 series switches, see
“Installing a Summit X460 Series Switch”
on page 192.
For instructions to install the Summit X480 series switches, see “Installing a Summit X480 Series Switch”
on page 207
.
For instructions to install the Summit X650 series switches, see
“Installing a Summit X650 Series Switch”
on page 224.
To Next Page
Loading...
Need help?
General
