8 Removing Switches from Service
Removing a switch from service is a two-step process:
1 Disconnect the switch from its power source, following these steps as applicable:
•
Disconnect and remove the switch's removable AC power supply. See "Adding or Replacing
Power Supplies, Fans, and Expansion Modules."
•
Disconnect the switch from its redundant power supply.
2 Remove the switch from the rack, following the steps in Removing the Switch from the Rack on
page 49.
Note
Read the information in this chapter thoroughly before you attempt to remove a switch.
VSP 4900 Series Switches: Hardware Installation Guide 48
To Next Page
Loading...
