Extron electronics MAV Plus Series - Installing the Software

CrossPoint / MAV Matrix Switchers • Matrix Software
5-2
Matrix Software
Matrix Switchers Control Program
The Windows
®
-basedExtronMatrixSwitchersControlProgramcommunicates
withtheswitcherviatheEthernetLANport,therearpanelRemoteRS-232/RS-422
port,andthefrontpanelConguration(RS-232)port(matrixsizesupto1616)
to provide an easy way to set up ties and sets of ties. The program is compatible
withWindows2000,WindowsXP,andlater.Updatestotheseprogramscanbe
downloadedfromtheExtronWebsite(http://www.extron.com).
Installing the software
TheprogramiscontainedontheExtronSoftwareProductsCD-ROM,diskB.
Installthesoftwareasfollows:
N
For full functionality, install both of the following programs:
 • TheMatrixSwitchersControlProgram
 • TheFirmwareLoader
1. InserttheCD-ROMintothedrive.Theinstallationprogramshouldstart
automatically.Ifitdoesnotself-start,runLaunch.exefromtheCD.
 TheExtronsoftwareCDwindowappears(gure5-1).
Figure 5-1 — Software CD window
2. Click the Software tab (figure 5-1).
3. ScrolltothedesiredprogramandclickInstall(gure5-2).
Figure 5-2 — Software installation