Extron electronics MAV Plus Series - I;O Controls

Operation, cont’d
CrossPoint / MAV Matrix Switchers • Operation
3-8
f
Esc (
>
) button — The Esc (
>
)buttonhastwoprimaryfunctions(•)andsix
secondary functions (❏):
• Canceloperationsorselectionsinprogressandresetthefrontpanel
button indicators.
N
The Esc (
>
) button does not reset the current configuration, the RGBHV
(CrossPoint switchers) or Video (MAV Plus switchers) button and Audio
selection button, any presets, or any audio gain or attenuation or volume
settings.
• Flashesoncetoindicatethattheescapefunctionhasbeenactivated.
❏ IntheI/O Groupmode,selectgroup4andindicatetheselection.
See“I/Ogrouping”onpage3-24.
❏ (CrossPoint switchers)IncreasetheRGBdelayofswitchestotheselected
output.See“SettingRGBdelay(CrossPointSwitchers)”onpage3-28.
❏ (Audio models)Increasetheaudioleveloftheselectedinput.
See“Viewingandadjustingtheinputaudiolevel(audiomodels)”on
page3-38.
❏ (Audio models)Increasethevolumeoftheselectedoutput.
See“Viewingandadjustingtheoutputvolume(audiomodels)”on
page3-44.
❏ WiththeEnter,Preset,andViewbuttons,selectSerial Port Selection and
Configurationmode.See“SelectingtherearpanelRemoteportprotocol
andbaudrate”onpage3-54.
❏ Select115200baudfortherearpanelRS-232/RS-422portinSerial Port
Selection and Configurationmodeandindicatetheselection.See“Selecting
therearpanelRemoteportprotocolandbaudrate”onpage3-54.
I/O controls
N
Throughout this chapter, the terms “RGBHV button” and “Video button” are
used interchangeably.
Primary functions
Action/
indication:
Selectvideo.
Green when selected
Selectaudio.
Red when selected
RGBHV
or
VIDEO
AUDIO
Secondary functions
Front panel
locks
Action 1:
With Enter, select Lockmode2and/ortoggle
betweenmode0andmode2.
Action 2:
SelectLockmode1and/ortogglebetweenmode0
and mode 1.
RGB delay Action/
indication:
SelectRGB Delay mode.
Blinks green.
Resets Action:
Performasystemreset
Port
conguration
Action/
indication:
SelectRS-232.
Blink: selected
SelectRS-422.
Blink: selected
Audio Action/
indication:
SelectAudio mode.
Blinks red.