Extron electronics MAV Plus Series - Change the Input Gain and Attenuation (Audio Models)

HTML Operation, cont’d
CrossPoint / MAV Matrix Switchers • HTML Operation
6-14
Change the input gain and attenuation (audio models)
Userscanseteachinput’slevelofaudiogainorattenuation(-18dBto+24dB)from
theRGBandAudioSettingspage.Audiolevelscanbeadjustedsothereareno
noticeable volume differences between sources.
Change an input’s audio level setting as follows:
1. ClicktheInputdropbox.Adropdownscrollboxappears(gure6-12).
Figure 6-12 — Input selection drop box
2. Click and drag the slider or click on the scroll up
button or scroll down
button until the desired input is visible.
3. Click the desired input.
4. ClicktheInputAudioLevel(dB)dropbox.Adropdownscrollboxappears
(gure6-13).
Figure 6-13 — Gain drop box
5. Click and drag the slider or click on the scroll up
button or scroll down
button until the desired input is visible.
6. Click the desired gain or attenuation value.