Extron electronics MAV Plus Series - Change the Output Volume Level (Audio Models)

6-17
CrossPoint / MAV Matrix Switchers • HTML Operation
Change the output volume level (audio models)
Userscanseteachoutput’svolumelevelthrougharangeofzerostepsof
attenuation(fullattenuation,minimumvolume)to64stepsofattenuation(no
attenuation,fullvolume)fromtheRGBandAudioSettingspage.
Change an output’s audio level setting as follows:
1. Clicktheoutputdropbox.Adropdownscrollboxappears(gure6-18).
Figure 6-18 — Output selection drop box
2. Click and drag the slider or click the scroll up
button or scroll down
button until the desired output is visible.
3. Click the desired output.
4. ClicktheVolumeSteps(64Max)dropbox.Adropdownscrollboxappears
(gure6-19).
Figure 6-19 — Volume drop box
5. Click the desired output volume step value.
N
The table on the next page defines the value of each audio volume step.