Extron electronics MAV Plus Series - File Management Tab; File Management Page

6-11
CrossPoint / MAV Matrix Switchers • HTML Operation
6. Click the Firmware Upgrade link.
7. Click the Browse button. An open file window appears.
8. Navigatetothefolderwhereyousavedthermwareupgradele.Selectthe
file.
N
Valid firmware files must have the file extension “.S19”. Any other file
extension is not a firmware upgrade.
N
The original factory-installed firmware is permanently available on the
CrossPoint or MAV switcher. If the attempted firmware upload fails for any
reason, the switcher automatically reverts to the factory-installed firmware.
9. Click the Open button.
10. Click the Upload button. The firmware upload to the switcher may take a few
minutes.
File Management Tab
File Management Page
Todeletelessuchasuser-suppliedHTMLpagesfromtheswitcherortoupload
yourownlestotheswitcher,clicktheFileManagementtab.Theswitcher
downloadsthelemanagementHTMLpage(gure6-9).
Figure 6-9 — File Management page
N
The files listed in figure 6-9 are shown for example only and may not be present
on your switcher.
To delete a file, click the Delete button adjacent to the unwanted file.
Uploadyourownlesasfollows: