Extron electronics MAV Plus Series - Uploading HTML Files

Matrix Software, cont’d
CrossPoint / MAV Matrix Switchers • Matrix Software
5-18
Uploading HTML files
YoucancreatecustomizedHTMLpagesfortheswitchertodisplay.TheHTML
FilesListwindow(gure5-14)providesawaytoviewthecontentsofthe
switcher’slesystemandtouploadcustomHTMLpagestotheswitcher.
Figure 5-14 — HTML Files List window
UploadHTMLpagesasfollows:
N
The files listed in figure 5-14 are shown for example only and may not be present
on your switcher.
N
The HTML Files List window is for inserting your custom HTML pages. This
is not the window to replace the firmware that controls all switcher operation.
See “Updatingfirmware”, earlier in this chapter, to replace the firmware.
N
The following characters are invalid in file names:
{space} + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
1. ConnectthePCtotheCrossPointorMAVswitcherviaeitherserialportorthe
LAN port.
2. StarttheMatrixSwitchersControlProgramandconnecttothe
CrossPointorMAVswitcher.See“UsingtheMatrixSwitcherControl
software”inthischapter,steps1 through 4,startingonpage5-4.
3. Click on Tools > HTML File Manager.
4. Click the Pick File(s) to Load to Server button. An open file window
appears.
5. NavigatetothefolderwhereyousavedtheHTMLle(s).Selectthele(s).
N
To select multiple files, hold the Ctrl key while you select the desired files.
N
If you want one of the custom HTML files that you created to be the default
start-up page, name the file “index.html”. The switcher looks for that file name
when you first connect to it using an Internet browser.
6. Click the Openbutton.Thele(s)uploadtotheCrossPointorMAVswitcher
may take a few minutes.
7. Click the Update button to confirm the upload.
8. Click the ClosebuttontoexittheHTMLFilesListwindow.