Extron electronics MAV Plus Series - Page 53

3-9
CrossPoint / MAV Matrix Switchers • Operation
You must specify video, audio, or both when you are creating or viewing a
conguration.ThisisdonewiththeRGBHVbutton(CrossPointswitchers)or
Videobutton(MAVPlusswitchers)(
g
) and Audio (
h
) buttons.
g
RGBHV (CrossPoint) button or Video (MAV Plus) button — The RGBHV
(CrossPoint)orVideo(MAVPlus)buttonhasoneprimaryfunction(•)and
five secondary functions (❏):
• Selectsanddeselectsvideoforacongurationthatisbeingcreatedor
viewed and lights green to indicate that video is available for configuring
or for viewing.
❏ With the Enter button and Audio button, selects between front panel
locks (Lock mode 2 and Lockmode0).See“Settingthefrontpanellocks
(Executivemodes)”onpage3-52.
❏ With the Audio button, selects between front panel locks (Lock mode 2
and Lockmode1).See“Settingthefrontpanellocks(Executivemodes)”
on page 3-52.
❏ With the Audio button, commands the front panel system reset.
See“Performingasystemresetfromthefrontpanel”onpage3-53.
❏ (CrossPoint switchers) SelectstheRGB delay mode, in which you can
settheRGBdelay.See“SettingRGBdelay(CrossPointSwitchers)”on
page3-28.
❏ SelecttheRS-232protocolfortherearpanelRS-232/RS-422portin
Serial Port Selection and Configuration mode and indicate the selection.
See“SelectingtherearpanelRemoteportprotocolandbaudrate” on
page3-54.
h
Audio button —TheAudiobuttonhasoneprimaryfunction(•)andve
secondary functions (❏):
• (Audio models) Selectsanddeselectsaudio(orRS-232ifthesecondary
wirepairissetforRS-232)foracongurationthatisbeingcreatedor
viewed and lights to indicate that audio is available for configuration or
viewing.
❏ (Audio models) SelectstheAudio mode, in which you can adjust the
inputaudiolevelandtheoutputaudiovolume.See“Viewingand
adjustingtheinputaudiolevel(audiomodels)”onpage3-38and
“Viewingandadjustingthelocaloutputvolume(audiomodels)” on
page3-44.
❏ WiththeEnterbuttonandRGBHV/Videobutton,selectsbetweenfront
panel locks (Lock mode 2 and Lockmode0).See“Settingthefrontpanel
locks (Executivemodes)”onpage3-52.
❏ WiththeRGBHV/Videobutton,selectsbetweenfrontpanellocks(Lock
mode 2 and Lockmode1).See“Settingthefrontpanellocks(Executive
modes)”onpage3-52.
❏ WiththeRGBHV/Videobutton,commandsthefrontpanelsystemreset.
See“Performingasystemresetfromthefrontpanel”onpage3-53.
❏ SelecttheRS-422protocolfortherearpanelRS-232/RS-422portin
Serial Port Selection and Configuration mode and indicate the selection.
See“SelectingtherearpanelRemoteportprotocolandbaudrate”on
page3-54.