Extron electronics XTP II CrossPoint Series Setup Guide

12 XTP II CrossPoint Series • Installation
Remote Control
NOTE: See item
C
and item
D
on figure 2 on page 4,
figure 3 on page 5, and figure 4 on page 6.
C
LAN (Ethernet) port — If desired, connect a network WAN
or LAN hub, a control system, or a computer to the Ethernet
RJ-45 port (see TP connectors on the next page to wire the
connector).
NOTE: The factory default IP address is 192.168.254.254.
D
Remote RS-232/RS-422 port — If desired, connect a control
system or computer to the rear panel Remote RS-232/RS-422
port (see Remote port connector on page 18 to wire the
connectors).
NOTE: The XTP System Configuration software CANNOT
interface with the matrix switcher via the Remote
RS-232/RS-422 port. A third-party control system or a
computer issuing SIS commands can use this port.
Reset
NOTE: See item
E
on figure 2 on page 4, figure 3 on
page 5, and figure 4 on page 6.
E
Reset button — Initiates four levels of reset of the matrix
switcher. For different reset levels, press and hold the recessed
button wile the matrix switcher is running or while you power up
the matrix switcher.
See the XTP II CrossPoint Series User Guide, available at
www.extron.com.
Power
NOTE: See item
F
on figure 2 on page 4, figure 3 on
page 5, and item
G
on figure 4 on page 6.
F
Power connector — Plug the matrix switcher into a grounded
AC source.
G
Attached AC power connector —
North America — Plug the power cord into a
NEMA L6-20 220 VAC, 60 Hz power outlet (see
the drawing at right).
Other regions — Install a 200-240 VAC power
connector, standard for the matrix switcher
installation site, and plug the power cord into a
200-240 VAC, 50-60 Hz power outlet.
L6-20R
North America
X:
Hot Y: Hot
G: Ground
G
X
Y

Extron electronics XTP II CrossPoint Series Specifications

General

Brand	Extron electronics
Model	XTP II CrossPoint Series
Category	Matrix Switcher
Language	English