Extron electronics XTP II CrossPoint Series Setup Guide

XTP II CrossPoint Series • Configuration48
Configuration
Removing and Installing a Board or Blank Panel
NOTES:
• For proper cooling and air ow, boards or blank panels
should be installed in all locations during normal matrix
switcher operations.
• The input and output boards are hot-swappable. You do
not need to power down the matrix switcher to remove and
install a board.
Circuit boards can be added or removed to increase or decrease
the I/O conguration (size) of the matrix switcher. Remove and
replace an I/O board or blank panel as follows:
1. For a board, disconnect any connected cables.
2. Rotate the left and right knurled knobs to completely loosen the
captive screws.
3. Gently pull on the knurled knobs to loosen the board or panel
from the backplane.
4. Slide the board or panel out of the chassis (see figure 13 on
the next page).
ATTENTION:
• Do not touch the electronic components or the
connectors on the backplane or on the circuit boards
without being electrically grounded. Handle circuit
boards by their edges only. Electrostatic discharge can
damage circuits, even if you cannot feel, see, or hear it.
• Ne pas toucher les composants électroniques ou
les connecteurs sur la carte mère ou sur les circuits
imprimés sans être électriquement relié à la terre.
Manipuler les circuits imprimés en les tenant seulement
par leurs bords. Les ESD peuvent endommager
l’équipement, même si vous ne pouvez pas le sentir, le
voir ou l’entendre.
5. Place the removed board on an anti-static surface or in an
anti-static container.

Extron electronics XTP II CrossPoint Series Specifications

General

Brand	Extron electronics
Model	XTP II CrossPoint Series
Category	Matrix Switcher
Language	English