Page | 3
SYMBOLS
The WARNING symbol indicates a potentially hazardous condition/situation. The safety warnings throughout this
manual, and on your equipment, if any, are for the protection of people and property. Failure to abide by safety
warnings will result in a waiver of all liabilities, loss of your warranty, and could result in equipment damage and or
failure, property damage, risk of serious bodily injury, and or death, to operators, riders, and those nearby the symbol
may appear in various colors and in conjunction with other symbols.
The NOTE symbol indicates important information. Failure to obey all notes could result in improper operation, less-
than-optimum equipment performance, and at the sole discretion of the equipment manufacturer, may void your
warranty. The symbol may appear in various colors and in conjunction with other symbols.
WARNINGS
Prior to use, read and understand this manual and all other applicable manuals, including supplements and
addendums, if any, and warning labels, in their entirety. Learn and understand the location and function of all features,
Rated Load, safety devices, and labels before use. If you do not understand which manuals apply, or their content, do
not use the VPL and call 1-800-451-1903 for further information.
Do not remove safety labels. Maintaining all labels and manuals in legible condition is required by the VPL owner and is
essential for safe VPL operation. If labels are missing, damaged, or become illegible, they must be replaced by VPL
owner. A missing or illegible label will fail to alert individuals on or around the VPL of a procedure or hazardous
operating conditions. For replacement copies, please call 1-800-451-1903.
VPL Rated Load is 750 lbs. (340 kg.). Do not exceed Rated Load.
Do not use VPL if Top Landing Gate is not secure and or functioning improperly.
Do not use VPL for anything other than its intended purpose of personal residential use for lifting of individuals and
personal mobility devices.
Keep all body parts away from moving components and within the platform guards during VPL operation.
The Platform Safety Rail is required for anyone who will be standing on the VPL.
Never play on or near the VPL.
Turn mobility device’s power ‘OFF’ and engage the brake prior to use on the VPL.
Remove ice, snow, leaves, and all potentially unsafe materials from VPL and landings before each use.
Inspect VPL for damaged, missing, or inoperable parts before each use. Never use a damaged or unstable VPL.
Annually (more often in harsher environments), check all fasteners and verify all nuts, bolts, screws, and other
fasteners are undamaged and secure. Contact your dealer to schedule any needed inspections, repairs, or service.
Do not tamper with, attempt to repair, or modify any portion of the VPL. Only EZ-ACCESS approved technicians may
service the VPL. Contact your dealer to schedule inspections, repairs, or service.
Observe and avoid all pinch points.
Whenever not actively raising or lowering the VPL, turn keyed power switch to ‘OFF’ position and remove key.
Always unplug VPL from electrical outlet before cleaning. Only plug VPL back in when area around VPL is dry.
Never operate VPL with damaged electrical wires, cords, or plugs.
The VPL’s electrical cord must be routed and situated in a manner that poses no electrical or other hazards. Do not lay
power cords on or across electrically conductive materials, such as metals, and always route power cords in such a
manner so no one can trip over them and that they are not exposed to risk of accidental or incidental damage.
The AC electrical plug on this VPL is grounded and intended to be used only with a properly grounded GFCI outlet. If AC
electrical wire ground pin is broken or missing, immediately contact your dealer to schedule repairs.
Stop using VPL and immediately contact your dealer for inspection, repairs, or service if any defect is suspected.
Use VPL only with a qualified helper.
Do not use VPL to support, attach, or hang planters, baskets, lights, adornments, decorations, clothing, fabrics or other
ornamentals or furnishings.
Annual (more frequent in harsher environments) inspections by an EZ-ACCESS approved technician are required.
Contact your dealer to schedule any needed inspections, repairs, or service.
Before and while operating VPL, ensure hair, clothing, shoelaces, jewelry, and other personal items do not catch onto
anything that may create a hazard.
Correct installation, proper use, following instructions and obeying VPL safety warnings are necessary for safe
operation.
Do not operate a VPL that has not been properly anchored to the reinforced concrete pad.
Do not operate VPL while occupied until VPL is properly anchored (and braced, when bracing is required). Operating
the VPL, while occupied, before installation is complete is hazardous.
Unless servicing or inspecting the VPL, always keep all panels and protective coverings in place.
Only EZ-ACCESS approved technicians may service the VPL. Contact your dealer to schedule any needed inspections,
repairs, or service.
Caustics and high alkaline detergents and solutions should not be used to clean aluminum.
To Next Page
Loading...
Need help?
General
