10.
POST-INSTALLATION AND BEFORE USE INSPECTION
10.1 Inspect the TILT to make sure all components are working properly.
10.2 Use the handheld control to cycle the unit up and down (see ‘SECTION 9’ for more information), making
sure it’s free from obstructions and working properly. Ensure that all hardware is in place and that the
TILT operates properly.
10.3 For questions or concerns, please call 1-800-451-1903 or consult your Certified Dealer or Technician.
11.
CLEANING / SANITIZATION / MAINTENANCE
11.1 For hygiene and safety, diligent cleaning, sanitization, and inspection of the TILT is essential and each
situation may have unique requirements. For example, multiple users may have different health and
sanitization needs than a single user. It is important that an effective cleaning and sanitization schedule
be established that fits your situation. You may clean debris and soils from the TILT using a soft cloth
with warm water and mild soap, noting that while soap and water may remove debris, additional
methods are needed to sanitize the TILT. Ensure all potential contaminates are removed and the TILT is
sanitized before and after each use.
11.2 DO NOT use toilet bowl cleaner or abrasives on the TILT or any of its components.
Prior to cleaning the TILT, ensure the battery is disconnected from the control box and the battery
charger is unplugged from the wall.
Ensure all components are dry prior to re-assembly and use of the TILT.
11.3 To access the removable plastic shield for cleaning, use the handheld control to raise the TILT into its
“up” position.
11.3.1 Lift toilet seat.
11.3.2 Remove the plastic shield (FIG. 26) by grabbing it from the front and lifting upward, then
pulling forward until the shield slides out of the TILT.
11.3.3 Lower toilet seat.
11.4 To re-insert the plastic shield:
11.4.1 Lift toilet seat.
11.4.2 Insert the plastic shield (FIG. 26) by aligning cutouts over the support rollers.
11.4.3 Lower toilet seat.
To Next Page
Loading...
Need help?
General
