TITAN
™
Code Compliant Modular Access System Installation Manual
WARNINGS, CONT’D.
Annually (more frequent in harsher environments) inspect all fasteners and verify all nuts, bolts, screws, and
other fasteners are undamaged and secure. If any part of the system appears damaged, loose, or missing, do
not use until repaired by an EZ ACCESS approved technician.
Do not tamper with, attempt to repair, or modify any portion of the system. Only EZ-ACCESS approved
technicians may provide service.
Do not lean on, walk on, or otherwise bear weight on the system until installation is complete.
Consult local building codes for information on securing system for environmental loads.
Do not use if surfaces are cluttered, obstructed, or unsafe.
At all times, keep the system clear of dirt, leaves, and other debris that may accumulate on the surface.
Simply sweeping the system or using a garden hose will usually suffice, but, if needed, a damp cloth or soft
brush with mild dish soap and water can be used (avoid alkaline solutions). Rinse well and use extra caution
when system surface is wet.
If snow and or ice is present on the system, remove accumulations before use. Please refer to ‘DEICING’
section for more information.
Before each use, confirm the system is level and positioned securely. Periodically check for ground shifts and
make any necessary adjustments.
Do not sit, stand, or climb on guards, gates, or handrails. Do not play on or around system, including, but not
limited to, running, jumping, bicycles, scooters, skateboards, etc.
Properly support and restrain system in transit or storage.
If you have any questions, or would like additional care, usage, or general safety information, please call 1-
800-258-8503.
ATTENTION INSTALLER and END USER
Prior to use, read and understand this manual and all other applicable manuals, including supplements and
addendums, if any, and warning labels, in their entirety. Learn and understand the location and function of all
features, Rated Loads, safety devices, and labels before use. If you do not understand which manuals apply,
or their content, do not use the TITAN™ Code Compliant Modular Access System and call 1-800-451-1903 for
further information.
Leave this Installation Manual with the end user.
Fill out online warranty registration.
IMPORTANT SHIPPING INFORMATION
The shipment contains a packing list. Confirm all items are present before starting installation. Open
shipping boxes and inspect for damage or missing parts. If damaged or missing parts are noted, DO NOT
INSTALL OR USE.
Check for shipping damage immediately upon receipt and note any freight damage on freight bill while
driver is still present. Contact shipper right away with any freight damage concerns. In most cases, freight
damage claims will not be allowed unless noted on the freight bill. Pictures of damage before the unit is
unpacked can be very helpful.
TOOLS TYPICALLY REQUIRED
1/2″ SOCKET OR 1/2″ WRENCH
9/16″ SOCKET OR 9/16″ WRENCH
5/16″ SOCKET OR 5/16″ WRENCH
LEVEL
FILE
RUBBER MALLET
POWER DRILL
25’ TAPE MEASURE
#2 PHILLIPS HEAD SCREWDRIVER
5/16″ DRILL BIT (IF BRACE ASSEMBLIES ARE USED)
5/32″ ALLEN WRENCH
3/16″ ALLEN WRENCH
BOX KNIFE
HAMMER
1/4″ MASONRY DRILL BIT (IF INSTALLING TO
CONCRETE PORCH, STEP, ETC.)
DIGGING TOOLS (FOR SURFACE OBSTACLE REMOVAL)
HACKSAW (IF OPTIONAL HANDRAIL KITS ARE USED)
PLIERS
CLAMP
To Next Page
Loading...
Need help?
General
