EasyManuals Logo

Ezgo RVX User Manual

Ezgo RVX
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
38
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Manual
Battery Disposal
Return used batteries to the manufacturer or lead smelter for recycling. For neutralized spills, put residue in acid-resis-
tant containers with absorbent material, sand or earth and discard according to state and federal regulations for acid and
lead compounds. Contact authorized environmental authorities for information about disposal.
LIFTING THE VEHICLE
You must lift the front, the rear or the entire vehicle for some service and maintenance operations.
The vehicle is not stable during the lifting process.
Make sure the vehicle is on a hard and level surface.
Never get below a vehicle that is supported by a jack only.
Make sure a vehicle that is supported on jack stands is stable before you get below the vehicle.
Put wheel chocks in front and behind the wheels that remain on the ground.
Do not allow any person in or on the vehicle being lifted.
When you lift the vehicle, put the jacks and jack stands at the areas indicated only.
Tool List Qty. Tool List Qty.
Floor Jack.................................................................... 1 Jack Stands................................................................. 4
Wheel Chocks ............................................................. 4
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle while lifting.
How to Lift the Entire Vehicle:
1. Install wheel chocks in front and behind each front wheel.
2. Center the jack under the bagwell.
3. Lift the vehicle enough to place two jack stands under the frame where
the leaf spring mounting brackets are welded to the frame.
4. Lower the jack and test the stability of the vehicle on the two jack stands.
5. Place the jack under the center front just behind the bumper.
6. Lift the vehicle and place two jack stands under the frame where the
instrument panel support is attached to the frame.
7. Lower the jack and test the stability of the vehicle on the jack stands.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ezgo RVX and is the answer not in the manual?

Ezgo RVX Specifications

General IconGeneral
BrandEzgo
ModelRVX
CategoryUtility Vehicle
LanguageEnglish

Related product manuals