40
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Manual
Protect face and eyes when removing a tire valve core.
Use only sockets made for use with impact wrenches to decrease the risk of injury caused by a
broken socket.
Do not use tires that have a recommended tire inflation pressure less than the tire pressure
recommended.
Tire Repair
Tool List Qty. Tool List Qty.
Lug Wrench, 3/4”......................................................... 1 Impact Socket, 3/4” ..................................................... 1
Impact Wrench ............................................................ 1 Torque Wrench, ft. lbs. ................................................ 1
Use caution when you inflate the tires. Because of the low volume of the small tires, over inflation can occur in seconds.
Over inflation can cause the tire to separate from the wheel or cause a tire explosion.
The general recommended tire inflation pressure is 18-22 psi. Tire inflation pressure can be adjusted for the condition of
the terrain.
For outdoor applications with primary use on areas with grass, consider the following:
• Slightly higher tire inflation pressure is suitable on hard turf
• A lower pressure decreases the risk of tires cutting into a soft turf
For hard surfaces or pavement, tire inflation pressure must be in the higher allowed range, but not more than recom-
mended on the tire sidewall.
All four tires must have the same pressure for best control qualities. Always install the valve stem cap after you check or
inflate the tires.
The vehicle has low-pressure tubeless tires, installed on one-piece rims.
Use a tire plug to repair small holes in the tread part of the tire. For large holes and cuts, replace the tire.
Tire plug tools and plugs are available at automotive outlets. The tires do not have to be removed from the wheel to
install the tire plugs.
If the tire is flat, remove the wheel and inflate the tire to the recommended maximum pressure for the tire. Submerge the
tire in water to find the leak and mark with chalk. Install the tire plug according to manufacturers instructions.
Wheel Installation
To decrease the risk of component damage, do not tighten lug nuts to more than 63 - 77 ft. lbs. (85 - 105 Nm)
torque.
Always follow the cross-sequence pattern when you install the lug nuts to make sure the wheel is evenly seated
against the hub.
To Next Page
Loading...
Need help?
General
