Mt740/745, 741/746/En/Rev. 002/12/97 * 901.742 002
BEISSBARTH MT 740/ 745, 741/ 746
4-1
Clean rims and tyres.
Remove old balance weights.
Check wheel runout (using accessory meter P22).
Checking wheel and tyre
PREPARATORY WORK
Important:
Dirty or damaged clamping devices or wheels,
incorrect clamping devices (see table of flanges),
excessive or uneven tightening torques when
tightening the wheel studs at the flange or fitting
to the vehicle can cause balancing errors of 30
grams or more to occur.
Refer to the flange table for the
most satisfactory means of attaching a particular
wheel.
Clamping wheel onto flange
(For mt 741/ 746 only)
Push the complete flange (of the type suitable for
the wheel) on to the conical shaft and tighten the
retaining screw firmly with the Allen key
provided.
(The picture shows a middle-centring flange.)
Clamping the flange
To Next Page