Facom Beissbarth microtec 740 - Fault-Code Display

BEISSBARTH MT 740/ 745, 741/ 746
8-2
Fault-code display
Error 1: Drive/light barrier defective (service)
Error 2: Wheel speed unstable (service)
Error 3: Incorrect direction of rotation
Error 4: Residual imbalance too large
(for zero alignment only)
(service, if necessary)
Error 5: Sensor/ adjustment weight out of
tolerance
(for alignment with weight only)
(service, if necessary)
Error 6: Amplification channel out of
tolerance or A/ D converter
defective (service)
Error 7: NV-RAM faulty
(keyboard circuit board)
(service)
Error 8: Align distance spot mechanically
(service)
Error 9: RAM defective
(CPU circuit board)
(service)
Error 10: Incomplete input data
Error 11: Printer table full
Error 12: Safety hood not closed
Error 13: Potentiometer not in alignment
position or faulty
(for potentiometer alignment only)
(service, if necessary)
Error 14: Wheel-rim data input unacceptable
for alignment
(for alignment with weights only)
Important:
Whenever repair work is carried out or parts
are exchanged ensure that only spare parts or
standardised parts from the appropriate
BEISSBARTH spare part list are used.