Mt740/745, 741/746/En/Rev. 002/12/97 * 901.742 002
BEISSBARTH MT 740/ 745, 741/ 746
7-1
WHEEL-BALANCING PROCEDURE
Note:
In Germany, a wheel safety hood with electric
interlock is required by law.
The machine drive may only be switched on
with the safety hood closed.
Close safety hood.
The machine starts automatically.
The wheel-balancing process takes approx. 3
seconds. After this period the machine auto-
matically brakes and stops.
The imbalance values and the direction are
indicated on the screen.
Imbalance value:
Indicated by two large red digital figures for
the inner and outer wheel planes.
Direction:
Indicated by large red direction arrows which
become shorter as the balancing point is
neared.
When the balancing point is reached, the red
direction arrows go out and the colour of the
imbalance value displays changes from red to
green.
Make sure that the balance weight for both
planes is always attached in the 12-o'clock-
position.
A test run can be performed to check the
wheel-balancing result.
The digital displays indicate "000" in white if
wheel balancing is correct.
Stop key (16)
The wheel-balancing process can be interrupted
at any time with this key.
Start key (15)
Wheel balancing can be re - started with this
key.
To Next Page