BEISSBARTH MT 740/ 745, 741/ 746
5-2
1.Push the rim distance gauge away from
the zero position and up against the inner
rim flange, then wait for the acoustic
signal.
The microprocessor has now stored the
rim distance and measured the rim dia-
meter; both values are displayed on the
screen.
2.Push the rim width gauge away from the
zero position and up against the outer rim
flange, then wait for two acoustic signals.
The microprocessor has now stored the
rim width value, which is displayed on the
screen.
3.If the rim diameters are known, these can
also be entered via the rim diameter key
(2) and rim width key (3) at the numerical
keypad (14).
/
To Next Page