Faema BARCODE - Selection Repetition Function; Coffee Dose Variation

SELECTION REPETITION Function
This function can be activated in various ways:
1) setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu). .
Note: To have access to customer programming,the function
must have been previously enabled by the installer “Technician
programming/Configuration/Customer prog. YES”.
2) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
Note: This second mode can be used only if the “Technician
programming/Configuration/Dispensing Stop: NO” WAS
NOT enabled by the installer.
The number of dispensed drinks programmed is indicated on
the top left of the display. Press the
key and keep pressed
for about 3 sec. to reset.
NOTE. These functions are deactivated when error messages
and/or codes are displayed and the item “Technician program- “Technician program-
ming/
Configuration /Program. block” is set on “YES".
The machine is equpped with a software program that makes
it possible to quickly change the coffee dose without needing
the technician’s assistance.
Note: This function is possible ONLY if the entry “bean key”,
in the technical configuration menu, has been set to “YES” by
the installer.
To modify the coffee dose, access the programming key (Tp)
and press the “bean” key
(BK). The following will appear
on the display:
Press the key (32) for which you want to vary the coffee dose.
The following will appear on the display:
Use the “+”
(30) and “-” (31) keys to set the number.
Coffee dose variation
 CUSTOMER PROG.
KEY MENU
MM1 cof. dose 064
-5 064 +5
-
+
The dose set for both grinders in the technician programming
menu can vary by ±5.
Example
Technician programming Customer programming
Coffee dose MM1 045 Coffee dose MM1 040÷050
Coffee dose MM2 020 Coffee dose MM2 015÷025
To exit the panel, press the key
to confirm any changes
made to the numbers or press the RES (24) key
to leave
the settings as is.
Tp
BK

32
32
54
English