DC Servo Drive System Manual Ver: 0009
DC - 4/32
1.1 INTRODUCTION
Fagor DCM motors (DC) are
especially designed to be
controlled by Fagor DC
servo drives.
These DC motors are easier
and less expensive to govern
than brushless motors.
Its mechanics is an industrial
standard.
DC Motors, DCM
DCM4 DCM2DCM5
(*) The diagram below shows
the meaning of the mounting
codes.
(**) IP44 means that it is protected against particles with
a diameter greater than 1 mm and against water splashes
in all directions.
Winding voltage 100-130 Vdc
Number of poles 2 (DCM2); 4 (DCM4 and DCM5)
Shaft end Cylindrical with keyway.
Mounting Face flange.
(meets IEC-34- 7-72) B14, V18, V19 on DCM2;
B5, V1, V3 on DCM4 and DCM5.
Mechanical tolerance Standard class (meets IEC 72/1971)
Bearings life 10000 hours
Balancing Class N (meets DIN 45665)
(balancing with keyway)
Noise Meets IEC 34-9-72
Brake (optional) 24 Vdc
Electrical Insulation Class F
Degree of protection IP44 (**)
Operating temperature range From 0°C to +40°C (32°F to 104°F)
Maximum overtemperature 130°C (266°F)
Thermal switch N. C. 120°C (248°F)
13 Amp (250 Vac); 18 Amp (24 Vdc)
Maximum altitude 1000 meters (1281 ft) above sea level.
Feedback 20 Volt/Krpm tachometer
2500 lines/turn encoder TTL
(***) The F class isolation on the motor maintain the
dielectric properties as long as the work temperature
stays below 155°C (311°F).
B14/B5 V18/V1 V19/V3
To Next Page
Loading...
