SECTION 4 - TROUBLESHOOTING
SUPPLY PROTECTION DEVICE
The appliance is fitted with a miniature circuit breaker (MCB) as additional protection against over current.
If unit fails to operate or show any operational indicators, Follow details in Error Code Table before calling a
service engineer. The symptoms may indicate a failed induction generator
SECTION 5 - ERROR CODES
DO NOT remove or attempt to repair or replace ANY part or parts of this appliance other than the air intake filter.
If an error occurs within the unit, the control panel LEDs will flash to indicate an error code.
The error code list that follows will help identify the faulty component.
In the “action by user” list, you should follow the action listed, before contacting a Service Engineer.
Note: Most faults can be rectified by simply
switching the unit off for 10 seconds. After this time,
turn the
power back on at mains supply. If the fault continues to occur after this action then
please refer to
the table. The following codes can be assessed by the user; any others will require a service engineer.
To Next Page
Loading...
