IA-Slot Parameters
Below is a list of the Parameters associated with an individual IA-Slots:
Page Parameters
Below is a list of the Parameters associated with an individual Page:
Defines what type of switch behavior to exhibit for this IA-Slot. STOMP, MOMENTARY, QUICK-TAP (ON
messages only), TAP-TEMPO (shows tempo speed)
On, Off, Bypass,
Blocked Colors
Defines the color to use for the IA-Slot based on the current status of the IA-Slot
Assigns a particular external device to “sync” with this particular IA-Slot
If a sync device is selected, then the available effects that can have live/active sync are selectable.
For sync device effects that have sub-sets, those sub-set parameters are chosen here.
When turned ON, the IA-Slot acts like a global switch and maintains its state from one preset to
another.
Defines the power-on state for a global IA-Slot.
The commands that will be triggered when an IA-Slot is turned ON, or set to ON in a preset (depending
on parameter settings).
BYPASS command
programming
The commands that will be triggered when an IA-Slot is bypassed. These commands will also be sent if
the state of the IA-Slot is “OFF” and the global parameter allows OFF to be sent as BYPASS.
Tells the page to allow Dynamic IA-Slot function allocation based on the Current State of IA-Slots. If a
button contains two functions, both of which being IA-Slots, then dynamic IA processing is available. If
Function #1 is ON or BYPASSED, then the initial function on the page button will be Function #1. If
Function #1 is OFF and Function #2 is either ON or BYPASSED, then Function #2 will become the active
To Next Page
Loading...