EXPRESSION PEDAL PROGRAMMING
This set of parameters allows you to program each of the four built in expression pedal ports. With the screen above,
press and to select the expression pedal port you wish to edit. Press
when ready.
Next you will need to select the type of expression pedal port you want to setup. Most expression pedal ports
operate as Continuous controllers, thus it is the default type. The following is a list of the supported expression
pedal programming types available:
Continuous pedals are those that transmit a value to a CC#.
Examples of this are Volume and WAH pedals. Once you establish
the MIDI chan and the CC# to process, you are complete. The
Controller will do the rest.
Latch pedals act as ON/OFF switches. When first pressed, the pedal
will send an ON message (value=127) to the CC# programmed.
When the pedal is pressed again, it will send an OFF message
(value=0). Typically a properly wired stomp switch would be
attached, however, a pedal could still be used.
Momentary pedals act just like a Latch, except that the ON
message is sent and the pedal waits for the user to let go of the
button. Once released, the OFF message is sent.
EXP Pedal Type
01 | Continuous
EXP Pedal Type
01 | Latch
EXP Pedal Type
01 | Momentary
Select EXP Pedal
01 | Continuous
To Next Page
Loading...