Each preset can establish the initial state of each IA Slot (1-60). The state can be OFF, ON, or STANDBY. Use the
and buttons to select the IA Slot to program. Use the and
buttons to select the initial State. Press when you set each state to a different
value.
Each preset can trigger up to 20 programming commands (See section on Programming Commands for details).
Programming commands must be in sequential order. The processing will stop when the first “EMPTY” command is
found within a preset. Press and buttons to select the command to program. Press
to select the next parameter to edit for the current command position. An Underline will
highlight to current parameter being edited. Remember to press to store your edits.
By default, presets will not change the active page being used by the controller. This setting is set to 0. Should you need
to modify the page, you can either (1) create a Programming Command, or utilize this parameter to set the specific page
to make active.
To Next Page
Loading...