command is found. Press and buttons to select the command to program. Press
to select the next parameter to edit for the current command position. An Underline will
highlight to current parameter being edited. Remember to press to store your edits.
Each IA Slot programmed as Type STOMP or MOMENTARY can trigger up to 20 OFF programming commands
when in the Bypass or OFF state. (See section on Programming Commands for details). Programming
commands must be in sequential order. The processing will stop when the first “EMPTY” command is found.
Press and buttons to select the command to program. Press
to select the next parameter to edit for the current command position. An Underline will
highlight to current parameter being edited. Remember to press to store your edits.
IA Switches are not global by default. An IA Switch can be “Local” or “Global”. Global IA Switches maintain their
state regardless of what preset is triggered. Normally a preset is loaded and has been defined with an initial
state for each of the 60 IA Slots. This initialization “overwrites” the current status of an IA Slot and replaces it
To Next Page
Loading...