Press to move to the next parameter. Once an expression pedal type is selected, you will
be given a parameter screen to enter the values. MIDI Channel, CC# will be requested.
Press to move to the next parameter. Once an expression pedal type is selected, you will
be given a parameter screen to enter the values. MIDI Channel, CC# will be requested.
Press to move to the next parameter. The Calibration screen will now show. Move the
expression pedal from TOP to BOTTOM three times. If a properly wired switch is connected, press it three times.
You should notice the scroll bar moving to confirm the pedals flow. Press to save your settings.
Continue to press to store all your settings. You can now go to the top of this section to program
the remainder of the used expression pedals.
To Next Page
Loading...